Eagle EVR-150 Spécifications télécharger pdf (Page 9)

9EAGLE - EVR-150 Installation and Operation Instructions

Fix the DSC label

Connect the Radio Cables

The connectors are on the rear of the base unit, as follows:

1. GPS/COM connector. For connection to GPS device via NMEA. See the following table

for wiring and color codes. (If you’re not using this, be sure to put the protective cap

securely over the connector to protect it from moisture and dust.)

2. External Speaker connector. Plug the external speaker cable jack into the connector

BEFORE powering on the radio. Use a 4 Ohm 4 Watt external speaker.

3. RED Power wire. Connect this to the POSITIVE (+) battery terminal. Check that a 10 Amp

fuse is installed on this power cable close to the battery.

4. BLACK Power wire. Connect this to the NEGATIVE (-) battery terminal.

5. ANT. A radio antenna is not supplied. A suitable radio antenna must be mounted

and connected before operating the EVR-150 radio. Consult your dealer for advice if

necessary.

6. GND. A ground connection is not usually required.

CAUTION

DANGER

WARNING

A DSC warning label is supplied with the EVR-150. To comply with FCC regulations, this

warning label must be aﬃxed in a location that is clearly visible from the operating

controls of this Eagle radio. Make sure that the chosen location is clean and dry before

applying this label.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Pas de commentaire

Eagle EVR-150 Spécifications Page 9