Eagle 320 Spécifications télécharger pdf (Page 33)

Sonar unit with external speed sensor.

The temperature sensor is built into the transducer.

Speed Sensor Installation

If you wish to purchase an optional sensor for your unit, refer to the

accessory ordering information inside the back cover of this manual.

The following instructions describe how to install the speed sensor.

Recommended tools for this job include: drill, 5/8" drill bit, 1/8" drill bit for

pilot holes, screwdriver. Required supplies for this job include: four #8

stainless steel wood screws (3/4" long), high quality, marine grade above-

or below-waterline caulking compound. (If you intend to route the sensor

cable through the same hole as the transducer cable, you will need a 1"

(25.4 mm) drill bit instead of the 5/8" drill bit.)

First find a location on the boat's transom where the water flow is smooth-

est. Don't mount the sensor behind strakes or ribs. These will disturb the

Temperature sensor

built into transducer

SP-U speed only

sor

Sonar unit

rear view

Power/trans-

ducer cable

12-volt battery

3-amp fuse

HST-WSU

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 103 104

Pas de commentaire

Eagle 320 Spécifications Page 33